After Use; Cleaning And Care - Cleanmaxx JJ-SC-005B Gebrauchsanleitung

4. Insert the mains plug in a properly installed socket that is easily accessible. The power LEDs (12)
behind the water tank will illuminate in red as soon as operating voltage is present. Wait until
the appliance has reached the operating temperature and the power LEDs are blue.
5. Start cleaning. Push the
to be emitted from the nozzle. You can now increase the quantity of steam by turning the knob
for the steam quantity control.
NOTE: After the knob is turned, it will take a few seconds until the respective steam quantity
is reached.
6. Slowly let the nozzle glide over the surface to be cleaned.
7. When the power LEDs blink red, there is too little water in the tank. Push the
switch before you fi ll the tank. Before you change the nozzle or once you have fi nished your
work, push the
the cord, but always on the plug.
8. Wait a few minutes for the appliance to cool off. Afterwards, you can change the nozzle.
9. Follow the instructions in the section "After use".

After use

1. Turn off the appliance and pull the mains plug.
2. After every use, take the water tank out of the main unit and empty it into a sink.
3. Let the appliance and accessories cool off completely.
4. Clean the appliance and fl oor pad after use as described in the chapter "Cleaning and care".

Cleaning and care

ATTENTION!
❐ Prior to each cleaning, pull the plug out of the socket.
❐ Scalding hazard! Always shut off the appliance and pull the mains plug out of the socket and let
the appliance cool off completely before you clean it or remove accessories.
❐ Scalding hazard! The fl oor pad may be very hot shortly after use. For this reason, wait a few
minutes for the cloth to cool off completely before you remove it.
❐ Never immerse the main unit in water or other liquids. Make sure that the main unit, the
power cord or the power plug can not fall in water or get wet.
❐ Never touch the main unit, the power cord or the power plug with wet hands.
❐ Do not use any solvents, abrasive cleaning agents or cleaning pads for cleaning. They could
damage the appliance.
❐ The nozzles are not suitable for the washing machine, dishwasher or dryer! Only air dry them
and do not in any case use a hair dryer.
3. Turn the knob for the steam quantity control (8) to the minimum
setting by turning it counterclockwise until it comes to a stop.
On / Off switch (13) on the back of the main unit and steam begins
On / Off switch and pull the mains plug out of the socket. Never pull on
27
On / Off