Standard Accessories; Prior To Operation - Hitachi M 8V2 Bedienungsanleitung

English
PRECAUTIONS ON USING ROUTER
1. Single-hand operation is unstable and dangerous.
Ensure that both handles are gripped firm ly during
operation.
2. The bit is very hot im m ediately after operation.
Avoid bare hand contact w ith the bit for any
reason.
SPECIFICATIONS
M odel
Voltage (by areas)*
Pow er Input*
Collet Chuck Capacity
No-load speed
M ain Body Stroke
Weight (w ithout cord and

standard accessories)

* Be sure to check the nam eplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) Straight Guide .......................................................... 1
(2) Bar Holder ................................................................. 1
Guide Bar .................................................................. 2
Feed Screw ............................................................... 1
Wing Bolt .................................................................. 1
(3) Tem plate Guide ........................................................ 1
(4) Wrench ....................................................................... 1
(5) Wing Bolt (A) ........................................................... 4
(6) Lock Spring ............................................................... 2
(7) Dust collector set (Fig. 17) ........................................ 1
Be sure to check standard accessories on product as it is
subject to change by areas.
Standard accessories are subject to change w ithout
notice.
OPTIONAL ACCESORIES - sold separately
(1) Tem plate Guide
A
16.5 m m 18 m m
18.5 m m 20 m m
25.5 m m 27 m m
28.5 m m 30 m m
7
11000 – 25000 m in
Bottom of Sub
base
B C
4.5 m m
M 8V2
(110V, 120V, 220V, 230V, 240V)
1150 W
8 m m or 1/4"
–1
60 m m
3.6 kg
(2) Chuck Sleeve (8 × 6)
20 m m
(3) Trim m er Guide (Fig. 14)
(4) Collet Chuck (8 m m )
(5) Collet Chuck (1/4" )
(6) Fine adjustm ent knob (Fig. 17)
Optional accessories are subject to change without notice.
APPLICATIONS
Woodw orking jobs centered on grooving and
cham fering.

PRIOR TO OPERATION

1. Pow er source
Ensure that the pow er source to be utilized conform s
to the pow er requirem ents specified on the product
nam eplate.
2. Pow er sw itch
Ensure that the pow er sw itch is in the OFF position.
If the plug is connected to a receptacle w hile the
pow er sw itch is in the ON position, the pow er tool
w ill start operating im m ediately, w hich could cause
a serious accident.
3. Extension cord
When the w ork area is rem oved from the pow er
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
M 8SA2
900 W
25000 m in –1
3.5 kg