JVC BR-DV3000E Bedienungsanleitung Seite 35

Setting
NTSC indicator
OPERATE
Mini A.DUB
DVCAM NTSC
PROFESSIONAL
CH-1/3
MIC REMOTE SEL. INPUT SEL.
CH-2/4
SERIAL LINE
9PIN WIRELESS DV Y/C
INPUT SEL. switch
Memo
•
For DV signal input, the sig-
nal system (NTSC/PAL) is
identified automatically.
•
For DV signal input, the AU-
DIO MODE item cannot be
set. It will be the same mode
as that of the input signal.
(48K or 32K)
AUDIO/VIDEO menu
– – – A U D I O V I D E O – – –
A U D I O MO D E 4 8 K
A O U T A T S E A R C H O N
A U D I O O U T S E L C H - 1 / 2
A U D I O O U T L E V E L N O RM
S E T U P ( N T S C ) O F F
P A G E B A C K
SYSTEM (1/2) menu
– – – S Y S T E M [ 1 / 2 ] – – –
S T L / F . A D V 2 N D
B A C K U P R E C T I M E O F F
L O N G P A U S E T I M E 5 M I N
L O N G P A U S E MO D E F . A D V
I N D E X W R I T E O N
R E P E A T MO D E B L A N K
N E X T P A G E
P A G E B A C K
BR-DV3000_E_p03-49
PAL indicator
EJECT
MENIU
REC PLAY PAUSE
PAL REC INH.
SET
REW STOP FF
BR-DV3000
Setting the signal system (NTSC/PAL)
The signal system for analogue input is set with the NTSC/PAL
switch located at the rear panel. Either the NTSC or the PAL indica-
tor on the front lights up, depending on the setting.
* Before setting the NTSC/PAL switch, please set the unit to the
OPERATE OFF mode.
Selecting the video input signal
Please use the INPUT SEL. switch on the front panel.
Y/C : Input Y/C separate video signals.
LINE: Input composite video signals.
DV : Input DV signals.
Setting the AUDIO/VIDEO menu (
• AUDIO MODE
Use this menu item to set the audio sampling frequency for recording.
32K : Perform recording with an audio sampling frequency of 32kHz.
Use this setting when performing audio dubbing on CH3 and
CH4.
48K : Perform recording with an audio sampling frequency of 48kHz.
Audio dubbing is not available.
• SET UP (NTSC only)
Set this item to enable/disable setup to composite signals or Y/C
separate video during recording.
Setting the SYSTEM menu ( ☞ Page 57)
• LONG PAUSE TIME
Sets the time period, after the lapse of which the unit will enter the
tape protection mode when pause is activated for an extended pe-
riod of time.
• INDEX WRITE
This setting turns on/off automatic recording of index signals when
recording begins.
Setting the time code recording during DV signal input
Set the TC DUPLICATE item of the TIME CODE menu to determine
whether to use the time code from the built in time code generator
and clock or the data from the DV terminal. (
35
Rear panel
DIO VIDEO
Y/C
LINE
CH 2/4
REMOTE
9PIN SERIAL
NTSC/PAL switch
☞
Page 61)
☞
Page 62)
13/01/03, 11:37 AM
DC12V
NTSC/PAL
NTSC PAL
E-35