JVC BR-DV3000E Bedienungsanleitung Seite 20

ON-SCREEN DISPLAY
No. Item
3
Time code
4
VTR operation mode
5
Remaining tape
Memo
If the display position of the
time code is set to the upper
right, this item will be dis-
played on the lower right.
E-20
BR-DV3000_E_p03-49
Status display
–
3 2 K C H – 1 / 2
S T A N D B Y - O F F
1 0 / 1 0 / 0 2
1 2 : 0 0 : 0 0 T C R 0 2 : 0 0 : 0 0 : 0 0
3
• It displays the time codes (hour, minute, second and frame).
During playback, the time codes recorded on the tape are
displayed.
TCR
TCG
DTCG : time code data input from a DV IN terminal
• The symbols for the second and frame differ according to the
framing modes. (NTSC only)
00 : 00 : 00 : 00
• The time code display position can be set via the COUNTER
POSI. item of the DISPLAY menu.
• The TIME CODE item can be set to turn on/off the time code
display.
• The user's bit is not displayed.
It displays the VTR operation modes, including:
PLAY, EJECT, FF, REW, STANDBY-ON, STANDBY-OFF, STILL,
REC, REC PAUSE, A. DUB, A. DUB PAUSE, SHTL (shuttle
search), JOG (F.ADV, R.ADV), BLANK SRH (blank search),
NO CASSETTE (cassette not loaded), OPERATE OFF.
When SHTL or JOG is displayed, the speed will also be dis-
played at the same time.
• The VTR MODE item of the DISPLAY menu can be set to
turn on/off the VTR operation mode display.
It displays the remaining tape duration (minutes).
If it is not identified, " – – – " is displayed.
• The TAPE REMAIN item in the DISPLAY menu can be set to
turn on/off the remaining tape duration display.
• The SP display disappears when the DVCAM cassette is
being played back.
• Please use the remaining tape time as a gauge.
20
– (continued)
5
0 0 0
S P m i n
4
Content
: time code reader data
: time code generator data
¥ dot (.) is used for a dropped frame.
colon (:) is used for a non-dropped
frame.
13/01/03, 11:36 AM