Warning Display - JVC BR-DV3000E Bedienungsanleitung

OTHERS
–
When an anomaly occurs, this unit automatically identifies the cause and displays an error-
coded warning message on the monitor.
If the unit is in a state needing rectification, or if an operation error has occurred, an alarm
display will be shown on the monitor.

Warning display

3 2 K C H – 1 / 2
W A R N I N G 7 0 0 1
D R UM MO T O R F A I L U R E
1 0 / 1 0 / 0 2
1 2 : 0 0 : 0 0 T C R 0 2 : 0 0 : 0 0 : 0 0
Alarm display (Displayed regardless of the DISPLAY mode)
Display
LOW VOLTAGE The DC power voltage is low.
The unit will eventually go into the OPERATE
OFF mode if operation is continued.
HEAD CLEANING The video head is dirty. If the head is clogged, it
REQUIRED! will be detected and the alarm message will be
displayed during the PLAYBACK mode. When
the STOP mode is engaged or when the cas-
sette is ejected, the display will go off.
When the head clog is cleared, the message
will disappear.
OVER HEATING! The internal temperature of the unit has ex-
ceeded the regulated value.
UNPLUG MAIN This is a system error that occurs when the
POWER, PLUG
power is turned on. The OPERATE indicator on
BACK IN AFTER A
this unit blinks in green. The unit will not accept
WHILE
any operation commands.
• For alarm displays resulting from operation errors, please refer to page 22.
E-66
BR-DV3000_E_p50-71
Warning display
0 0 0
S P m i n
S T A N D B Y - O F F
Status
66
–
Alarm display
3 2 K C H – 1 / 2
H E A D C L E A N I N G R E Q U I R E D !
S T A N D B Y - O F F
1 0 / 1 0 / 0 2
1 2 : 0 0 : 0 0 T C R 0 2 : 0 0 : 0 0 : 0 0
Action
Please check the power voltage.
Please clean it with the dedi-
cated head-cleaning tape.
☞
( Page 8)
If the message persists despite
cleaning, it could be due to bad
recording condition, bad tape or
lifespan of the head.
Please disconnect the power
and place the unit in a cool
place. If this message is dis-
played again, the unit may have
been damaged. Please consult
your JVC authorized dealer.
Unplug the power cord from the
power outlet and wait for some
time before plugging it back in.
13/01/03, 11:39 AM
0 0 0
S P m i n