Index Search; Blank Search; Locate Function - JVC BR-DV3000E Bedienungsanleitung

PLAYBACK

Index search

This function locates and advances/rewinds to the position where the index signal is recorded.
Use the remote controller.
REC
A.DUB PAUSE
F.REV F.ADV
PLAY
REW FF
STOP
INDEX– INDEX+
REMOTE CONTROL UNIT
RM-G3000
INDEX – INDEX +
button button
Monitor screen
INDEX+1
During index search, this message
is displayed on the monitor
(the number represents the position of
the index).

Blank search

This function locates the unrecorded parts of the tape. Use the remote controller.
BLANK button
DISPLAY
STILL
BARS BLANK
MODE
AUDIO
MENU SEARCH+ MUTING
OUT SEL.
Monitor screen
BLANK SEARCH
BR-DV3000_E_p03-49

Locate function

–
To locate an index in the forward direction vis-a-vis the
current tape position:
• Press the INDEX + button.
The index position to be located can be specified by the number
of times this button is pressed. (Max: 99)
To locate an index in the reverse direction vis-a-vis the
current tape position:
• Press the INDEX - button.
The index position to be located can be specified by the number
of times this button is pressed. (Max: 99)
When the INDEX + or INDEX - button is pressed, the unit
will fast-forward or rewind to the specified indexed po-
sition and start playing.
Memo
•
If the interval between index signals is less than 1 minute, the function
may not work well.
•
The specifications for index signal recording varies with the device used.
In the STOP mode, press the BLANK button.
• If the current position is at a recorded part of the tape, the unit
fast-forwards until an unrecorded part is reached and goes into
the STOP mode.
• If the current position of the tape is unrecorded, the unit will first
advance the tape in the forward direction for confirmation and
thereafter rewind and go into the STILL mode at the last recorded
position.
• During a blank search, "BLANK SEARCH" is displayed on the
monitor.
47
–
13/01/03, 11:38 AM
E-47