Names And Functions Of Various Parts; Front Panel - JVC BR-DV3000E Bedienungsanleitung

NAMES AND FUNCTIONS
OF VARIOUS PARTS
OPERATE
1
PROFESSIONAL
MIC
1
[OPERATE] Operate button/LED
● Press this button to turn on the power and op-
erate the unit. (Operate ON)
Press this button again to turn off the power.
(Operate OFF)
● The OPERATE LED lights up as follows.
Operate ON : the LED lights up green
Operate OFF : the LED lights up red
VTR error : the LED blinks in red
Memo
● When the DC IN MODE item of the SYS-
TEM menu is set to "OPE ON" and power is
1
supplied to the DC IN terminal located at
the rear panel, the unit goes into the OPER-
ATE ON state even if this button is not
pressed.
● Even when the power has been turned off
with this button, a small amount of electric-
ity will still be channeled into the unit.
Therefore, if the unit is not going to be used
for a long period of time, please remove the
AC adapter to reduce energy consumption.
2
Cassette slot
● Load a cassette into or unload it from the slot.
Please insert a standard DV or a mini DV cas-
sette. (☞ Page 30)
● When the unit is in the OPERATE OFF state
and if a cassette is loaded, it goes into the
ON state.
E-10
BR-DV3000_E_p03-49
A.DUB
Mini
DVCAM NTSC
CH-1/3
REMOTE SEL. INPUT SEL.
CH-2/4
SERIAL LINE
9PIN WIRELESS DV Y/C
4 3
10

Front panel

–
2
REC
PAL REC INH.
REW
BR-DV3000
3
[A. DUB] Audio dubbing button/LED
● Press this button for audio dubbing (after-re-
cording).
For audio dubbing, set the AUDIO MODE item
of the AUDIO/VIDEO menu to "32K".
Sound produced by the
9
the AUDIO IN terminal at the rear panel
(☞ Page 15) is recorded on CH3 and CH4
channels.
● During audio dubbing, the A. DUB LED lights
up red.
● If the INPUT SEL. switch is set at "DV", audio
dubbing is not possible.
(☞ Page 39, "Audio dubbing")
4
[INPUT SEL.] Input video signal se-
lection switch
● Select the video signal input with this switch.
Y/C : YC separate video signals from the Y/
C IN terminal
LINE : composite video signals from the LINE
IN terminal
DV : DV signals from the DV IN/OUT termi-
nal (IEEE1394)
Note
During recording, manipulating this switch will
not bring about any effect.
13/01/03, 11:35 AM
–
EJECT
MENIU
PLAY
PAUSE
SET
STOP FF
6
MIC terminal or