During Operation - Reely Su29 Bedienungsanleitung

• Batteries necessary for operation (e.g. remote control transmitter, receiver, flight battery), must be charged accor-
ding to the manufacturer's instructions.
• If batteries are used as a transmitter power supply, make sure that they have sufficient remaining capacity (battery
checker). If the batteries are empty, always replace the complete set, never individual cells only.
• Before each operation, check the settings of the trim slider on the transmitter for the different steering directions and,
if necessary, adjust them.
• Always switch on the transmitter first. Only then can the receiver system be taken into operation. Otherwise, there
may be unforeseeable reactions and, e.g., the propeller in an electric model may start up unexpectedly or the engine
may suddenly turn up to full throttle in a running combustion engine!
• Always check if the rotor is correctly and securely installed before operating the product.
• Regularly examine the propeller for damage. Damaged propellers pose a danger and no longer must be taken into
operation.
• Make sure that neither objects nor body parts are in the rotating and suction areas of the propeller while it is rota-
ting.
c) During Operation
• Do not take any risks when operating the product! Your own safety and that of your environment depends completely
on your responsible use of the model.
• Improper operation can cause serious damage to people and property! Therefore make sure to keep a sufficiently
safe distance to persons, animals or objects during operation.
• Select an appropriate site or hall for the operation of your model air plane.
• Only fly your model if your ability to react is unlimited. The influence of tiredness, alcohol or medication can cause
incorrect responses.
• Do not direct your model towards spectators or towards yourself.
• Never point the aerial of the transmitter directly onto the model. This significantly impairs signal transmission to the
model.
• Never switch off the remote control (transmitter) while the model is in use. After landing, always disconnect the flight
battery first or switch off the receiver system in the model. Only then must be remote control be switched off.
• In case of defect or malfunction, remove the cause of the interference before starting your model again.
• Never expose your model and the remote control system to direct solar irradiation or great heat for an extended
period.
24