Operation - Wolf Garten GT 840 Originalbetriebsanleitung

z Always wear appropriate working clothes and
sound footwear when using the trimmer.
z Before carrying the trimmer to the next lawn
area to be cut, switch it off.
z Be careful when you go backwards. You may
stumble!
z Keep the cable away from the cutting tool.
z Should the powercord be damaged during
use, immediately disconnect it from the mains.
Do not touch the cable until it has been discon-
nected from the mains.
z Never leave the trimmer without supervision.
Store it in a safe place.
z The switches installed shall not be removed or
bridged over, e. g. by binding the switch to the
handle.
z Do not allow the cord spool to strike the ground
or edges of working area. If the cord spool re-
ceives a hard knock, this will cause a strong vi-
bration on the handle. If this occurs, the
trimmer should be checked by a qualified ser-
vice centre.

Operation

Operating times
z Please check noise abatement regulations
prevailing in your country.
Settings
The lawn trimmer is equipped with a four-position
adjustable working angle. This enables you to
easily trim hard-to-reach areas in your garden.To
set the ideal working position, please follow the in-
structions below.
3
The cutting head should be inclined
slightly forward while trimming.
14
After operating
z After using the unit, disconnected the power
cord from the wall outlet and inspect the unit
for damage.
z When switching off the trimmer: Attention: the
cutting tool does not stop immediately!
z Always wait for the cutting tool is stop.
z Before examining or cleaning the tool or be-
fore removing the safety device or the cord
spool, switch off and disconnect the trimmer
from the mains. Only use original WOLF cord
spools and note the installation instructions!
z The cutting knife should not be cleaned under
running water or under high-pressure.
z Faults shall only be repaired by appointed ser-
vice centres or by the manufacturer.
z Make sure all air holes are free of dirt.
z Do not store the unit within reach of children.
Disposal
Do not dispose of electrical equip-
ment in domestic waste. Recycle
equip-ment, accessories and packa-
ging in an environment-friendly man-
ner.
Working angle and wheels
Free trimming - Working angle 1
Free trimming is especially suitable for trimming
large areas with high weeds or grass. During free
trimming, you should swing the trimmer in a semi-
circular motion in front of your body.
1. Set working angle
2. Remove wheels
Even trimming - Working angle 2
Recommendation: In order to achieve an even and
clean cut, you should use the wheels (see Acces-
sories).
1. Set working angle
H
2. Fit wheels .
3. Position wheels
A
E
.
G
.
B
E
.
J
.
G