Operating Times; Assembly; Operation - Wolf Garten LT 25 eM Originalbetriebsanleitung

Assembly

The power pack is permanently installed
in the operating arm.
Power pack charging must be carried out ac-
Î
cording to the instructions in the supplementary
documentation.

Operating times

Observe local regulations.
Î
Check with your local authorities to determine if
Î
there are any operating time limitations.
Assembly
Risk of injuries due to the cutting tool.
¾ Only adjust the device with the motor
switched off and the cutting tool at a standstill.
¾ Do not reach into the area of the rotating
line.
¾ Before any work on the device, remove
the operating arm with the permanently
installed power pack beforehand.
Fitting the protective cover A
Position the protective cover [A] on the motor
Î
housing 1 .
Fasten the protective cover to the motor
Î
housing [B] using the supplied screws [C] 2 .
Note
Only tighten the screws by hand.
Adjusting the working angle C
Risk of injuries due to the cutting tool.
¾ Only adjust the device with the motor
switched off and the cutting tool at a
standstill.
¾ Do not reach into the area of the rotating line.
¾ Before any work on the device, remove
the operating arm with the permanently
installed power pack beforehand.
The trimmer can be set in any of three different work-
ing angles. This allows you to easily reach problematic
and difficult-to-access positions in the garden.
Press and hold the locating button 1 .
Î
Set the working angle 2 .
Î
Release the locating button.
Î
3 The locating button of the lawn trimmer engages
audibly.
CAUTION!
WARNING!
WARNING!
Connecting the trimmer unit to the operating
arm B
Press the locking button [A] on the operating arm
Î
and insert the operating arm into the receptacle on
trimmer until the locking button [B] engages 1 2 .
Attention!
Ensure the button is correctly engaged.
Note
A middle handle is available as an optional
accessory for the operating arm. You can
find more information and assembly instruc-
tions in the operating manual for the
operating arm.

Operation

Incorrect handling of the power pack and
the charger
ÂRisk of injuries and material damage
¾ Read and observe the operating manual
of the operating arm and the charger.
Switching on the device D
Risk of injuries or material damage.
¾ Always hold on to the device with both
hands during operation. One hand holds
the handle, the other hand holds the
operating arm in the cased area or the
optionally available middle handle.
Press the lock-on switch [A] on the handle 1 .
Î
Simultaneously press the on/off switch [B] on the
Î
handle 2 .
Release the lock-on switch.
Î
3 The device operates.
Adjusting the line
Automatic
With each switching off and on the line is adjusted
out of the line cassette.
Note
Frequently switching on and off without
reason results in increased line wear.
Note
If the cutting line becomes too short during
operation due to wear, switch the device off
and then back on again to extend the
working length of the cutting line automati-
cally.
WARNING!
WARNING!
EN
23