Operation - Wolf Garten LI-ION POWER GTA 700 Originalbetriebsanleitung

Operation

Operating times
z Please check noise abatement regulations
prevailing in your country.
Charging
A B C
1
Attention! Only use battery charger in
dry places.
Before first use, the battery needs to be charged
for about 1,2 hours.
Use only the original WOLF-Garten charger
(part no. 41A30--E650)!
1. Remove the battery from the device
2. Insert the battery into the charger
3. Connect the charger to the mains voltage
(LED lights up green).
3
Notes on charger
z LED
lights up red: Battery is charging
z LED
lights up green: Charging com-
pleted
z LED
blinks red: Fault (e.g., battery is
too hot)
1
Self-discharge of batteries! Remove the
battery from the charger once it is fully
charged.
3
General instructions:
regarding the battery In order to maintain
the long service life of the battery, always
follow the instructions below:
z The lawn trimmer are automatically swit-
ched off when the battery voltage is low.
The battery must then be recharged be-
fore the shears can be used again.
z Always recharge the lithium-ion battery
prior to any prolonged period of non-use,
i.e. before storing the shears away in au-
tumn.
z The charging time is 1,2 hours for a battery
that is completely empty.
z The lithium-ion rechargeable battery can
be charged at any charge level and char-
ging can be interrupted at any time without
damaging the battery (no memory effect)
G
A
.
B
.
B
B
:
Working angle
D
The trimmer has 3-adjustable working angles. This
allows you to easily reach hard to reach areas in
your garden.
1. Press the lock button
2. Adjust to the desired working angle
handle noticeably snaps into place).
3
While working, the cutting head should
be tilted forwards slightly.
Adjusting the middle grip
z Adjust the height and angle of the middle grip
as desired according the figures.
Adjusting the grip height
1. Unscrew the threaded sleeve
2. Pull apart the telescope handle until the ideal
grip height is reached
3. Tighten the threaded sleeved
Working position
Free-cutting L
1. Hold the device at the upper and middle
grips .
2. Swing the device in semicircles in front of the
3 body (without touching the ground).
Note
3
The optimal working angle for cutting is 30°.
Plant protector
The plant protector protects shrubs trees
and bedding plants.
z Fold the plant protector downwards, if
necessary.
H
Edge-cutting
The edge-cutting function allows for precise trim-
ming along the lawn edge.
1. Pull the sleeves upwards
2. Turn the handle 180° until it clicks into
H
place .
3. Hold the device at the upper and middle
L
grips .
4. Run the device along the lawn edge (without
touching the ground).
.
E F
G
.
.
.
J
L
H
.
(the
15