Headless Mode - Reely DIY Bricked Drone Bedienungsanleitung

• When the aircraft
automatically flies backward
slowly, press the forward
trim button (5) until the
aircraft is in hovering flight.
• When the aircraft
automatically flies leftward
slowly, press the rightward
trim button (17) until the
aircraft is in hovering flight.
• When the aircraft
automatically flies rightward
slowly, press the leftward
trim button (15) until the
aircraft is in hovering flight.
b) Headless Mode
Headless mode is a relative control mode, i.e. no matter the alignment of the quadrocopter, it will always fly to the
right when viewed from the pilot's position when steering to the right - no matter if the model points backwards, to the
left, front or right with the camera (= front). The quadrocopter is shown the direction into which it is to go with the right
control lever (nod and roll) at all times.
• Start and Setup: When the power is turned on, normally the front side
of aircraft is the front side of headless mode after frequency matching.
If impacted or deviated on front side, please restart the aircraft again to
adjust the direction you need for frequency matching. When pressing the
headless mode button (8) the transmitter makes a beep sound and the
two front LED lights on the aircraft will flash indicating that the headless
mode starts.
• Exit the headless mode: Press the headless mode button again. The
transmitter makes makes a beep sound and the LED lights are solid bright
indicating to exit the headless mode.
Fig. 8
directional
Front
Fig. 9
43