Prevent Static Sparking Fire/Explosions - Storch EcoFinish Bedienungsanleitung

PREVENT STATIC SPARKING FIRE/EXPLOSIONS

Vapours from spraying can be ignited by sparks. To reduce the risk of fire, set up the turbine at least 6 m
from the area to be sprayed. Due not plug in or unplug power cables in the spraying area. The sparks this
causes can ignite the vapour still in the atmosphere. Observe the safety instructions and precautions of the
coating material and solvent manufacturers.
WARNING: Keep the turbine away from areas with hazardous concentrations of flammable vapors.
NEVER operate with the turbine inside a spray booth.
– NEVER point the spray gun at anyone or any part of the body.
– NEVER put your hand or fingers over the fluid nozzle.
– NEVER try to stop or deflect leaks with your hand, body, or rag.
– NEVER alter equipment in any manner.
– NEVER smoke in the spray area.
– NEVER spray highly flammable material with a low ignition point.
– NEVER use around children.
– NEVER allow another person to use sprayer unless he is thoroughly instructed on its safe use and given
this operator's manual to read.
– ALWAYS wear a spray mask/respirator, gloves and protective eye wear while spraying.
– ALWAYS ensure fire extinguishing equipment is readily available and properly maintained.
ALWAYS INSPECT SPRAYING AREA
– Keep the work area free of obstacles.
– Make sure the spraying area has good ventilation to safely remove vapors and mists.
– NEVER keep flammable material in spraying area.
– NEVER spray in vicinity of open flame or other sources of ignition.
– The spraying area must be at least 6 m away from the spraying system.
TOXIC FLUID HAZARD
Hazardous fluids or toxic vapours can cause serious to fatal injuries in case of skin or eye contact, inhaling or
swallowing. Familiarise yourself with the risks emanating from the coating materials you work with. Store
and dispose of hazardous liquids in line with your local and national regulations and the manufacturer's
instructions.
ALWAYS wear protective eyewear, gloves, clothing and respirator as recommended by fluid manufacturer.
HOSES
Do not allow kinking or crushing of hoses or allow it to vibrate against rough, sharp or hot surfaces.
NEVER use a damaged hose. Before each use, check entire hose for cuts, leaks, abrasions, or bulging. If
any of these conditions exist, replace the hose immediately.
Translation of the original instruction 70