Long Period Of Non-Use - clage Zip HydroTap G4 C 175 Gebrauchs- Und Montageanleitung

5. Using the Tap
'Settings'
Date/time – set the time and the time format.
Filter – enter the filter data in order to calculate the remaining filter capacity.
Energy saving – the unit's chilling function can be disabled when the unit is not in use,
to reduce the energy demand.
• Sleep mode automatically reduces the energy demand according to use or to the
ambient light.
• The time switch reduces the energy demand according to the time set. The date and
time must be correctly set on the unit for this to operate correctly.
Dispensing time – pull the lever on the tap forward and set the dispensing time.
Long period of non­use
Note: In ambient / warm water germs can multiply faster. Therefore, leave your
drinking water system switched on even during long periods of non­use.
If you still want to shut down your drinking water system for an extended period of
time, proceed as follows:
1. Turn off the water supply.
2. Tap chilled water until no more water flows to empty the system.
3. Switch off the appliance and disconnect it from power supply.
After prolonged non­use
1. Reconnect the water supply. Pay attention to any leaks.
2. Reconnect the appliance to the power supply and switch it on.
3. After non­use of several days: Drain at least 4 litres of cold water from the
fitting.
If necessary collect the water in a suitable container.
4. The appliance is now ready for use.
Note: If the system is not used for more than two months, the internal filter must
be replaced even if the change interval has not been reached!
Natural traces
The activated carbon contained in the filter is subject to natural fluctuations. By e.g.
vibrations during transport can result in slight abrasion of small coal particles. These
particles are harmless to health. If you see particles in the water, follow the instructions
in chapter 6 "Filter Replacement" sub point 7.
23
CLAGE
EN