Long Period Of Non-Use - clage Zip HydroTap Montageanleitung

Zip HydroTap ® MINIBOIL
5. Using the Tap
EN

Long period of non-use

Note: In ambient / warm water germs can multiply faster. Therefore, leave your
drinking water system switched on even during long periods of non-use.
If you still want to shut down your drinking water system for an extended period of
time, proceed as follows:
1. Turn off the water supply.
2. Tap ambient and hot water until no more water flows to empty the system.
3. Disconnect the appliance from the power supply.
After prolonged non-use
1. Reconnect the water supply. Pay attention to any leaks.
2. Reconnect the appliance to the power supply.
3. After non-use of several days: Drain at least four litres of ambient water from
the fitting. As soon as the LED in red lever lights up continuously, drain hot
water. Repeat this process until the LED flashes again.
If necessary collect the water in a suitable container.
Attention! There is a scalding danger at hot water!
4. The appliance is now ready for use.
Note: The filter and, if installed, the ion exchanger must be replaced if the system
is not used for more than two months, even if the change interval has not been
reached!
Natural traces
The activated carbon contained in the filter is subject to natural fluctuations. By e.g.
vibrations during transport can result in slight abrasion of small coal particles. These
particles are harmless to health. If you see particles in the water, follow the instructions
in chapter 6 "Filter Replacement" sub point 6.
20