Long Period Of Non-Use - clage G4 BCS 100/75 Gebrauchs- Und Montageanleitung

Zip HydroTap® G4 BCS100/75
5. Using the Tap

Long period of non-use

Note: In ambient / warm water germs can multiply faster. Therefore, leave your
drinking water system switched on even during long periods of non-use.
If you still want to shut down your drinking water system for an extended period of
time, proceed as follows:
1. Turn off the water supply.
2. Tap chilled, sparkling and hot water until no more water flows to empty the
system.
3. Close the CO -supply.
2
4. Switch off the appliance and disconnect it from power supply.
After prolonged non-use
1. Reconnect the water supply. Pay attention to any leaks.
2. Reconnect the appliance to the power supply and switch it on.
3. Open the CO -supply.
2
4. After non-use of several days: Start the CO
subpoint "Install") and subsequently drain at least 2 litres of cold water from
the fitting. As soon as the LED in the red lever lights up continuously, drain
hot water. Repeat the process until the LED flashes again.
If necessary collect the water in a suitable container.
Attention! There is a scalding danger at hot water!
5. The appliance is now ready for use.
Note: If the system is not used for more than two months, the internal filter must
be replaced even if the change interval has not been reached!
Natural traces
The activated carbon contained in the filter is subject to natural fluctuations. By e.g.
vibrations during transport can result in slight abrasion of small coal particles. These
particles are harmless to health. If you see particles in the water, follow the instructions
in chapter 6 "Filter Replacement" sub point 7.
28
-flush (see chapter 5 "Menu",
2