Grinding And Cutting Discs; Environmental Protection/Disposal; Maintenance - Protool AGP 230-22 Bedienungsanleitung

Continuous use
Push the safety lock-off lever (2) forwards to
release the On/Off switch lever (1).
At the same time, press the on-off switch lever (1)
and push the safety lock-off lever (2) forwards.
To turn off continuous operation, press and
release the on-off switch (1) again (1).
Starting current Limiter
The grinding machine is equipped with a resistor
which enables start-up with a small jerk and limi-
tation of the starting current, making it possible
to work in an electrical system with up to 10 A
protection.

Grinding and cutting discs

Check that the label on the disc shows the per-
missible peripheral speed or permissible revolu-
tion speed.
If the permissible revolution speed is given on
the disc, it must not be lower than the highest
no-load speed of the grinder.
Discs with a permissible peripheral speed of
80 m.s and higher may be used.
–1
Test new cutting discs by letting them run for
about one minute with no load.
Unbalanced or vibrating discs should not be
used and should be discarded.
Protect grinding discs from shock, impact and
lubricants.
If the grinding and cutting wheels are worn down
to the mark on the wheel guard (see the arrow
sign), they should be replaced with new ones.
This maintains the optimum grinding and cutting
performance of the machine (peripheral speed
of the grinding and cutting wheels).
Environmental Protection/
Disposal
Power tools, accessories and packaging should
be sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools
into household waste!
According to the European Directive
2002/96/EC on waste electrical and electronic
equipment and its incorporation into national
law, power tools that are no longer suitable for
use must be separately collected and sent for
recovery in an environmental-friendly manner.
16
Storage
The unit should be stored in a dry place where it
is protected against freezing.

Maintenance

� The ventilation holes (3) on the motor casing
must not get blocked up.
� The cable may only be replaced in a special-
ised electrical workshop qualified to perform
such work.
After approx. 200 hours of use the following
maintenance work must be performed:
� Check the length of the brushes. Brushes
shorter than 5 mm should be replaced.
� The machine turns itself off automatically when
the brushes are worn out. The machine must
be sent to a service centre for maintenance.
� Change the lubricant in the gearbox and
bearings.
To preserve the protection class the
machine must undergo a safety inspec-
tion; this must be done in a specialised
electrical workshop qualified to perform
such work.
Guarantee
Our equipment is under warranty for at least
12 months with regard to material or production
faults in accordance with national legislation. In
the EU countries, the warranty period for ex-
clusively private use is 24 months (an invoice or
delivery note is required as proof of purchase).
Damage resulting from, in particular, normal
wear and tear, overloading, improper handling,
or caused by the user or other damage caused
by not following the operating instructions, or
any fault acknowledged at the time of purchase,
is not covered by the warranty. Complaints will
only be acknowledged if the equipment has not
been dismantled before being sent back to the
suppliers or to an authorised PROTOOL customer
support workshop. Store the operating instruc-
tions, safety notes, spare parts list and proof of
purchase in a safe place. In addition, the manu-
facturer's current warranty conditions apply.
Note
We reserve the right to make changes to the
technical data contained in this information as a
result of ongoing research and development
work.