Assembly with the FASTFIX
quick-action fixing nut
Some versions of the machine are fitted with a
FASTFIX quick-action nut, which allows the
clamping of the grinding wheel without using
tools (see the notice on the packaging –
FASTFIX). This fixing nut can be tightened and
loosened by hand only (do not use any addi-
tional fixing tool!).
18
The mounting of the grinding wheel is carried
out in the same way as in the machine version
without the quick-action fixing nut but after
pressing the spindle � clamp the quick-action
fixing nut (18) can only be tightened by hand �.
Do not tighten the quick-action fixing nut
without the wheel. This might result in
damage to its mechanism.
AGP 230-22/26
Fitting the grinding disc – for
Australia
The mounting flange system is supplied in
3 pieces:
1. Backing Flange – used for both for Cut-Off
Wheels and Depressed Centre Grinding
Wheels
2. Centre Spacer – used for Cut-Off Wheels
3. Clamp Nut – used for Cut-Off Wheels and
Depressed Centre Grinding Wheels
Mounting: Cut-Off Wheels
The mounting of Cut-Off Wheels is done by
using the Backing Flange, Centre Spacer and
Clamp Nut.
�
Mounting: Depressed Centre Grinding Wheels
�
The mounting of Depressed Centre Grinding
Wheels is done by using the Backing Flange
and Clamp Nut.
Activation
Check that the information on the manufacturing
AGP 230-22/26 AB
label complies with the actual power supply
voltage.
Check that the plug type is the same as the
socket type.
Tools designed for 230 V may be connected to
220 V/240 V power supply.
Switching on and off
Push the safety lock-off lever (2) forwards to
release the On/Off switch lever (1).
At the same time, press the on-off switch lever (1)
to start the grinder and release it to stop.
Important! Use of Cut-Off Wheels without
the Centre Spacer will result in Cut-Off
Wheel damage and possible failure of
Wheel during operation.
Backing Flange
Center Spacer
Backing Flange
Clamp Nut
Clamp Nut
15