Technical Data; Maintenance - EINHELL 01017 Bedienungsanleitung

Anleitung RBK_3735_SPK1:_
GB
always stand on the uphill side.
1. Log supported along entire length: Cut from
top (overbuck), being careful to avoid cutting into
the ground (Fig. 16A).
2. Log supported on 1 end: First, cut from bottom
(underbuck) 1/3 diameter of log to avoid
splintering. Second, cut from above (overbuck) to
meet first cut and avoid pinching (Fig. 16B).
3. Log supported on both ends: First, overbuck
1/3 diameter of log to avoid splintering. Second,
underbuck to meet first cut and avoid pinching
(Fig. 16C).
Note: The best way to hold a log while bucking is to
use a sawhorse. When this is not possible, the log
should be raised and supported by the limb stumps or
by using supporting logs. Be sure the log being cut is
securely supported.
Bucking using a sawhorse (Fig. 17)
For personal safety and ease of cutting, the correct
position for vertical bucking is essential (Fig. 17).
A. Hold the saw firmly with both hands and keep the
saw to the right of your body while cutting.
B. Keep the left arm as straight as possible.
C. Keep weight on both feet.
Caution: When working with the saw, always
make sure that the saw chain and chain bar are
sufficiently lubricated.
24
06.07.2007 8:40 Uhr Seite 24

8. Technical data

Engine displacement
Maximum engine capacity
Bar length
Cutter rail length
Chain pitch
Chain thickness
Idling speed
Maximum speed with cutting equipment
Tank capacity
Oil tank capacity
Anti-vibration function
Chain wheel teeth
Chain brake
Clutch
Automatic chain lubrication
Low-kickback chain
Net weight without chain and chain bar
Net weight (dry)
Fuel consumption (specific)
L sound pressure level
pA
L sound power level
WA
Vibration a
Vibration a
Chain type
OREGON (91VG053)/CARLTON (N1C-BL-52E SK B)
Bar type
OREGON (140SDEA041)/QIRUI (PO14-50SR)
Spark plug

9. Maintenance

Warning: All maintenance work on the chainsaw
apart from the work described in this manual may
only be carried out by authorized after-sales service
personnel.
9.1 Chain brake operational test
Test the chain brake periodically to ensure proper
function.
Perform a chain brake test prior to initial cutting,
following extensive cutting, and definitely following
any Chain brake service.
14" (35 cm)
(3/8"), 10 mm
(0.05"), 1.27 mm
11000 rpm
6 x 9.525 mm
560 g / kWh
(front handle) max. 5.35 m/s
hv
(rear handle) max. 4.67 m/s
hv
37.2 cm 3
1.2 kW
32 cm
3000 rpm
310 ml
210 ml
Yes
Yes
Yes
Yes
Yes
4.2 kg
5.2 kg
104 dB(A)
114 dB(A)
2
2
L8RTF