Prepare Measurement - Beurer BM 19 Gebrauchsanleitung

4. Prepare measurement

Inserting battery
• Remove the battery cover from
the back of the monitor.
• Insert four AA 1.5 V alkaline
batteries. making absolutely
sure that you insert them with
the correct polarity as marked.
Never use rechargeable bat-
teries.
• Replace the battery cover carefully.
If the battery change
measure ment is no longer possible and you must replace all
the batteries. Once batteries have been removed from the
device, the time must be reset. The stored measured values
are last.
Used batteries do not belong in the household waste. You are
legally obliged to dispose of the batteries. Dispose of them via
your specialist electrical supplier or local collec ting point for
recyclable waste.
Note: Batteries containing pollutant substances
are marked as follows: Pb = Battery contains
lead, Cd = Battery contains cadmium, Hg = Bat-
tery contains mercury.
Setting date, time and language
It is vital to set the date and time. This is the only way that measure-
ments can be saved and recalled with the correct date and time.
The time is shown in 24 hour format. The device also has five
languages. The device is set to German on delivery.
4x 1,5 V AA (LR6)
is continuously illuminated,
Proceed as follows to set the date, time and language:
• Press the memory button M for over 5 seconds.
• The day starts flashing. Use the +/- key to set the day from 1
to 31 and confirm with the memory button M.
• Set the month, hour and minute and confirm in each case
with the memory button M.
• After setting the date and time you can set the language.
• Use the + and - volume keys to select the following lan-
guages: L1 = German, L2 = Italian, L3 = French, L4 = Span-
ish, L5 = Russian, L0 = no language. Confirm your selection
with the memory button M.
• You can then set the volume of the selected language:
Vol 3 = high, Vol 2 = medium, Vol 1 = low. Confirm your
selection with the memory button M.
Note: Language off (L0) means that voice output is not
selected and the measurement value will not be announced.
Mains operation
You can also operate this device with a mains adapter. No bat-
teries should be in the battery compartment for this. The mains
adapter is available from retailers or from the service address
under order no. 071.13. The blood pressure monitor should
only be used with the mains adapters specified here. The
mains adapter should only be connected to the mains voltage
indicated on the rating plate. Once you have disconnected the
device from the mains, the date and time on the blood pres-
sure monitor are lost. Any measurement results that have been
stored are however retained.
17