Insulation Mode; Temperature Warning; Total Reset - Fronius Galvo Serviceanleitung

Insulation mode

Activation and setting of the insulation monitoring
Selection options
Insulation warning
for activating and deactivating the insulation monitoring, with display of a warning without
interruption of feed-in if there is an insulation fault
Selection options
Threshold warning
for setting an insulation threshold at which the inverter produces a warning (without inter-
ruption of feed-in)
Setting range
Unit
Insulation fault
for activating and deactivating the insulation monitoring, with error message and immedi-
ate shutdown of the inverter if there is an insulation fault
Selection options
Threshold error
for setting an insulation threshold at which the inverter produces an error message and
interrupts grid power feed operation
Setting range
Unit
Temperature for activating / deactivating the overtemperature warning for each event;
warning the overtemperature warning is sent and displayed on the monitor.
Selection options

TOTAL reset

In the LOG menu item, resets the max. and min. voltage values and the max. power of
feeding in to zero.
Once values have been reset, this action cannot be undone.
To reset the values to zero, press the "Enter" key.
"CONFIRM" is displayed.
Press "Enter" again.
The values are reset and the menu is displayed.
54
Insulation warning / Threshold warning / Insulation fault /
Threshold error
ON / OFF
Depends on country setup
kOhm
ON / OFF
0 - 1000
kOhm
ON / OFF