Wifi Box & Pelletcontrol - Austroflamm Ben Benutzerhandbuch

16. Disconnect the mains power supply.
17. The battery is located on the circuit board. To do this, you must first remove the side panel.
18. Use insulated pliers or a similar tool to remove the old battery from its holder. Make sure that you
do not bend the contacts of the battery holder.
19.
Insert the new battery making sure that the correct polarity is maintained (see Abbildung 3:
Austauschen der Batterie.
20. Reconnect the mains power supply.
8. Wifi box & PelletControl
As-standard, models Polly 2.0 and Percy are fitted with a Wifi box; you can retrofit the Wifi box as
an accessory for the Ben, Percy light and Polly light models. The Wifi box allows you to integrate
your pellet stove into your existing wifi network and to monitor and control it using your smartphone
(under iOS and Android).
Download the necessary app PelletControl and start it:
Apple iOS
The system displays the following prompt: "Have you connected the heating device to your wifi
)
network yet?" "No"
"Your heating device will be connected to a wifi network": Enter your wifi password here and press
the wifi button on the wifi box on the back of the stove. The LED there starts to flash faster. While
the LED is flashing fast, press "Start wifi setting" on your smartphone.
When the wifi LED is lit up permanently and the status LED is flashing, press "Stop wifi setting" on
your smartphone.
Navigate back to where you are prompted to enter your MAC address and pin code (see the sticker
on the wifi box). Enter the data.
When all the LEDs are lit up permanently, press "Connect".
79
Figure 12: Replacing the battery
Google Play / Android
english
Button battery
CR2032
-
+