First Steps - Austroflamm Ben Benutzerhandbuch

2. First steps

It's this easy to commission your pellet stove:
1. Remove the accessories from the pellet tank, fill it up completely with pellets and close the tank
cover.
2. Plug in the mains cable.
3. Set the rocker switch on the back of the pellet stove to I.
4. The Austroflamm logo is displayed on the control panel. After a few seconds, the display changes
to this view:
5. If you want, you can change the display language (the
control panel that you have to tap or hold down):
) )
6. Tap the bar for the pellet tank at the bottom left ("FILL UP"). Then state that the pellet tank is full.
7. Start the stove:
) )
(keep pressed)
8. When you use your pellet stove for the first time, the pellet screw conveyor is completely empty.
This means that you must use the "Manual feed" function to fill the screw conveyor before putting
it into service.
Tap the screen (if it is still in idle mode) to leave idle mode. If the display is not currently in idle
mode, skip this step.
) )
Activate manual feed by keeping the "Feed" symbol pressed. After keeping the symbol pressed
for 30 seconds, manual feed is deactivated again automatically. If 30 seconds was not enough to
fill the screw conveyor, hold the symbol again. Repeat the procedure until the first pellets start
dropping into the burner bowl (this can take up to five minutes).
9. After a few minutes, the pellets start burning.
65
) ) )
)
) ) )
''Manual feed''
)
symbol indicates the icons on the
"language / Sprache"
english