Activating The Eco Mode Function; Standby Mode Settings; Setting The Loudspeaker Volume - Austroflamm Ben Benutzerhandbuch

Tap the screen (if it is still in idle mode) to leave idle mode. If the display is not currently in idle mode, skip
this step.
) )
brightness"
Set the desired display brightness in idle mode by tapping the
disp. bright." label. The system saves the changes immediately.
!
NOTE: If automatic brightness adjustment is active, this option is deactivated.

4.12. Activating the eco mode function

If the temperature rises above the target value, the heating device switches off automatically. It is
restarted automatically when the temperature drops below the target value.
To activate/deactivate the eco mode function, proceed as follows:
Tap the screen (if it is still in idle mode) to leave idle mode. If the display is not currently in idle mode, skip
this step.
) )
Tap "On" to activate.
Select the desired "Restart temp." This temperature specifies the value below the set target temperature
from which onwards the stove switches back on.
Select "Eco Mod. Temp." This temperature specifies the value above the set target temperature from
which onwards the stove switches off.

4.13. Standby mode settings

The control panel switches to standby mode automatically after 30 seconds of inactivity and leaves this
mode when you touch it again. Depending on the settings for standby mode, the control panel shows the
following:
The time, the air temperature, the logo or a sequence of these displays
x
The status of the heating device (if it is OFF)
x
Fuel autonomy (if activated)
x
Error/alarms (if present)
x
To make idle display mode settings, proceed as follows:
Tap the screen (if it is still in idle mode) to leave idle mode. If the display is not currently in idle mode, skip
this step.
) )
Activate the information that you want to display in standby mode by tapping the ''On/Off'' symbol
(multiple selection is possible).

4.14. Setting the loudspeaker volume

You can set the volume of the integrated loudspeakers or switch them off altogether.
To select the desired loudspeaker volume, proceed as follows:
73
) ) )
.
"Display options"
) )
''Eco mode'',
) ) )
.
"Display options"
)
"Display
and/or symbols next to the "Idle
)
"Standby mode"
english