Display Brightness; Setting Automatic Brightness Adjustment; Setting Active Display Brightness; Setting The Display Brightness In Idle Mode - Austroflamm Ben Benutzerhandbuch

english
Tap the screen (if it is still in idle mode) to leave idle mode. If the display is not currently in idle mode, skip
this step.
) )
The system displays the following:
Tap FULL after you have topped up with fuel
Tap ''OK'' to save your settings. The fuel bar shows full:

4.11. Display brightness

You have different options on the control panel for setting the brightness of the display. Thanks to the
integrated ambient light sensor, the control panel can adapt the display brightness automatically.
4 .11 .1 . Set ting aut omat ic brig ht nes s ad just ment
Tap the screen (if it is still in idle mode) to leave idle mode. If the display is not currently in idle mode, skip
this step.
) )
)
brightness"
4 .11 .2 . Set ting act ive d isp lay b r ig ht nes s
Tap the screen (if it is still in idle mode) to leave idle mode. If the display is not currently in idle mode, skip
this step.
) )
brightness"
Set the desired display brightness by tapping the
label. The system saves the changes immediately.
!
NOTE: If automatic brightness adjustment is active, this option is deactivated.
4 .11 .3 . Set ting the d is p la y b r ig ht nes s in id le mod e
You can increase or decrease the display brightness in idle mode to save energy. When you touch the
keypad, the display brightness is increased to the default value.
To set the display brightness in idle mode, proceed as follows:
72
)
) ) )
.
''Automatisch OFF/ON''
) ) )
.
and/or
)
"Display options" "Display
)
"Display options" "Display
symbols next to the "Brightness active"