Charger And Handpiece; Transport And Storage Conditions; Installation Of The Unit; Factory Settings - 3M Espe elipar Betriebsanleitung

Light emission area:
Intermittent operation: 1 min on, 15 min off
Total exposure time
with new, fully
charged battery:
Dimensions:
Weight:
Typ B

Charger and Handpiece

Time to charge
empty battery:
Operating temperature: 10° C up to 40° C /
Relative humidity:
Atmospheric
pressure:

Transport and Storage Conditions:

Ambient temperature range: -20° C up to +40° C /
Relative humidity:
Atmospheric pressure:
Subject to technical modification without prior notice.

Installation of the Unit

Factory Settings

The factory settings of the device are as follows:
• 10 sec exposure time
4
60-65 mm (optically active)
2
(ambient temperature of 40° C)
typically 7 min operating time at
ambient temperature (23° C)
Typically 60 min
Diameter: 28 mm
Length: 270 mm
180 g (incl. light guide)
Approx. 2 h
59° F up to 104° F
30% up to 75%
700 hPa up to 1060 hPa
-4° F up to +104° F
+40°C
+104°F
–20°C
–4°F
75%
max.
30%
1060
hPa
700

Initial Steps

Charger

Select the plug adapter specific to the country and
place it on the charger.
Plug adapter

Light Guide/Handpiece

Place the glare shield on the front of the device.
Autoclave the light guide prior to first use.
Then attach the light guide to the handpiece until it
noticeably locks into place (see Section "Removing
and Inserting the Light Guide from/into the Hand-
piece").
If the device malfunctions, insert the charger plug
into the charging socket of the handpiece. The device
will reset itself and can then be used again.

Battery Charging

The device contains a powerful lithium-ion recharge-
able battery. This type of battery does not have any
Charger