Product Description; Fields Of Application; Technical Data; Charger - 3M Espe elipar Betriebsanleitung

Light guide

Product Description

Elipar is a high-performance light source for the poly-
merization of light-curing dental materials. The device
has two components: a wireless handpiece with a built-in
battery which can be replaced by 3M ESPE customer
care and a charger. The device is a medical electrical
device in accordance with IEC 60601-1 and is available
as a tabletop device. Wall mounting is not possible.
The light source is a high-performance light-emitting
diode (LED). In contrast to halogen lights, the emitted
light specifically covers the light wavelength between
430 and 480 nm, the relevant range e.g. for camphor
quinone-containing products.
The polymerization performance is so high that the
exposure times can be reduced by 50% in comparison
with a conventional halogen light (with light intensity
typically ranging from 600 to 800 mW/cm
filling composites can be cured in as little as 5 seconds
if the light guide can be used in their immediate
proximity. Manufacturer's instructions for light-curing
dental materials regarding layer thickness, exposure
time, and light intensity must be followed at all times.
Filling composites which can be cured in 5 seconds are
shown in the list included with the device.
Settable exposure times:
• 5, 10, 15, 20 sec
• Continuous mode (120 sec)
• Tack-cure mode
Place the handpiece on a flat surface when not in use.
The handpiece can be connected to the charger between
applications so that the battery is charged. The hand-
piece must be connected to the charger at the
latest when the battery power level display glows red
steadily so that the battery is charged (cf."Battery Power
Level Display on Handpiece").
The device is shipped with a light guide with 10 mm
diameter. It is not permissible to use the light guides of
other devices.
Glare Shield
The handpiece is equipped with a sleep mode to mini-
mize the device's energy consumption. The handpiece
switches to sleep mode if it is not used for a period of
about 5 minutes or the incorrect charging voltage is
detected.

Handpiece

The charger uses a maximum of 0.2 W when ready for
operation.

Fields of Application

• Polymerization of light-curing dental materials with

Technical Data

Charger

Operating voltage:
Nominal consumption: 0.2 A max
Dimensions without
country-specific
adapter:
). Selected
2
Weight:
Classification:
Manufacturer:
Model:
Handpiece
Power supply:
Utilizable wavelength
range:
Wavelength peak:
Light intensity (between
400 and 515 nm):
These Operating Instructions should not be
discarded for the duration of use of the device.
photo initiator for the wavelength range 430-480 nm.
- Though the majority of light-curing dental materials
are responsive in this range of wavelengths,
you may wish to contact the manufacturer of the
material in question.
100-240 V 50/60 Hz
Length: 65 mm
Width: 40 mm
Depth: 31 mm
75 g
Protection class II,
Click Technology Co., Ltd.
CPS 008050100
Lithium-ion battery,
nominal voltage 3.7 V,
capacity 2300 mAh
430-480 nm
455 nm +/-10 nm
1200 mW/cm
(independent of battery power
level)
-10%/+20%
2
3