Kärcher KM 100/100 R D Betriebsanleitung Seite 24

Pull out the filter holder to the maximum
possible extent and lock.
Remove the lamella filter.
Insert new filter.
Make sure driver engages with holes on
drive side.
Lock the handle of the filter cleaner
back into place.
Note: Make sure when installing the new
filter that the fins are not damaged.
Replacing filter case seal
Lift filter case seal out of groove in the
cover.
Insert new seal.
24
Checking drive belt
Check tension of drive belt and V-belt of
the suction blower, also check for wear
or damage.
Check tension, wear and damages on
the V-belt of the sweep roller drive.
Check cup seal
Chek the cup seal at the suction blower
regularly to see that it sits properly.
Replacing fuses
Loosen screws on both sides of the
panel.
Replace defective fuses.
Replace front panel.
9
-
EN
The fuse for the electric starter is locat-
ed in the engine compartment.
Note: Only use fuses with identical safety
ratings.
Check engine oil level and top up, if re-
quired
Note
The engine is equipped with an oil deficien-
cy switch. When the fill level is insufficient,
the engine switches off and can only be re-
started once the engine oil has been re-
plenished.
Danger
Risk of burns on account of hot surfaces!
Allow engine to cool down.
Remove the oil dipstick and check the
oil level: Minimum content 1/3.
If the oil level is less than 1/3, top up en-
gine oil until it reaches the lower edge of
the filler opening.
Wait at least 5 minutes.
Check engine oil level again.
Change the engine oil
Danger
Risk of burns on account of hot surfaces!
Pull out oil dipstick.
Draw off engine oil via the oil filler neck
using 6.491-538 oil-change pump.
Fill with fresh engine oil via oil filler neck
using clean 6.491-538 oil-change
pump.
Wait at least 5 minutes.
Check engine oil level again.
Cleaning and replacing the fuel filter
Release the wing nuts on the suction
container.