Before Startup - Kärcher KM 100/100 R D Betriebsanleitung

Before Startup

Unloading
Danger
Risk of injury and damage! Do not use a
forklift to unload the appliance.
To unload the machine, proceed as follows:
Cut plastic packing belt and remove foil.
Remove the elastic tape fasteners at
the stop points.
Four indicated floor boards of the pallet
are fastened with screws. Unscrew
these boards.
Place the boards on the edge of the pal-
let. Place the boards in such a way that
they lie in front of the four wheels of the
machine. Fasten the boards with
screws.
Slide the four support beams included
in the packaging under the ramp.
Remove the wooden blocks used for ar-
resting the wheels and slide them under
the ramp.
Moving sweeper without engaging
self-propulsion
Danger
Risk of injury! Before engaging the free-
wheel operation, the machine must be se-
cured to prevent it rolling away.
Opening and securing cover
Engage freewheel lever in upper hole.
This blocks the travel drive function.
Close cover.
The machine can now be pushed.
Note
Do not move the machine for long distanc-
es without engaging self-propulsion, a
speed of 6 km/h should not be exceeded.
Moving sweeper by engaging self-
propulsion
Engage freewheel lever in lower hole.
The travel drive is now ready for operation.
Close cover.
The appliance can now be driven.
Start up
General notes
Park the sweeper on an even surface.
Remove the key.
Refuelling
Refuelling the machine
Danger
Risk of explosion!
– Only use the fuels specified in the Op-
erations Manual.
– Do not refuel the machine in enclosed
spaces.
– Smoking and naked flames are strictly
prohibited.
– Ensure that no fuel reaches the hot
open surfaces.
Switch off engine.
Opening and securing cover
Check fuel level via the tank indicator.
Open fuel filler cap.
Fill in diesel.
Fill tank to max. 1 cm below the lower
edge of the filler nozzle.
Wipe off any spilt fuel, remove funnel
and close fuel filler cap.
Close cover.
4
-
EN
Operation
Adjusting driver's seat
Open the hood, insert retaining rod.
Release the wing nuts from the seat
rails.
Slide the seat into the desired position.
Tighten the wing nuts.
Note: If this adjustment is not enough, it
can be adjusted more.
Remove 4 screws on the plate of the
seat contact switch.
Remove the plate.
Swivel the seat to the front.
Loosen 4 screws on the seat support.
Slide the seat and tighten the screws.
Install the plate of the seat contact
switch.
Programme selection
1 Driving
Driving to the Place of Use.
2 Sweeping with sweep roller
Roller brush is lowered. The roller brush
and the side brush will rotate.
3 Sweeping with side brushes
Roller brush and side brushes are low-
ered.
19