Technical Specifications - Kärcher KM 80 W G Handbuch

Inhaltsverzeichnis

Verfügbare Sprachen

Fault

Engine does not start

Reduced motor output

Engine is too hot

Engine is running but machine is

not moving

Machine is not sweeping properly Check roller brush for wear, replace if necessary.

KM 80 W G

Machine data

Length x width x height (pushing handle unfolded)

Length x width x height (pushing handle folded in)

Net weight (transport weight)

Driving and sweeping speed

Climbing capability (max.)

Climbing ability with attachments (max.)

Roller brush diameter

Working width

Engine

Type

Cylinder capacity

Max. speed

Minimum speed

Max. power

Fuel type

Fuel tank capacity

Spark plug, NGK

Oil grades

Engine oil - type

Filling quantity

Tyres

Drive wheel

Tyre pressure

Working conditions

Temperature

Air humidity, non-condensing

Values determined as per EN 60335-2-72

Noise emission

Sound pressure level L

Uncertainty K

Sound power level L

+ Uncertainty K

Machine vibrations

Hand-arm vibration value

Uncertainty K

Subject to technical modifications!

Troubleshooting

Remedy

Check setting of gas lever

Refuel

Open fuel cock

Drain bad or old fuel from the tank and the carburettor, fill in fresh fuel

Check and clean spark plug, replace if necessary.

Check air filter, clean if required.

Check bowden cable to the motor

Inform Kärcher Customer Service.

Have the carburettor adjusted.

Fill in motor oil

Adjust the Bowden cable of the acceleration drive

Inform Kärcher Customer Service.

Lower or raise the roller brush by means of the height adjustment

Readjust Bowden cable of the sweeping drive

Inform Kärcher Customer Service.