Herunterladen Diese Seite drucken

Emptying The Waste Water Tank - Kärcher BD 38/12 C Bp Originalbetriebsanleitung

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Recommended detergents:
Application
Regular cleaning
(even for floors sensitive
to alkalies)
Cleaning dirt from
grease
Basic cleaning (strip-
ping) of alkali-resistant
hard coatings
Basic cleaning (strip-
ping) linoleum
Base cleaner, acidic
Disinfection cleaning
Detergents are available in specialised
stores.
 Close the cover of the fresh water res-
ervoir.
 Place the waste water tank on the appli-
ance.
Settings
 Release the star knob for the height ad-
justment of the push rod.
 Adjust the push handle to the desired
height.
 Tighten the star handle.
 Adjust the dosing of the cleaning solu-
tion in accordance with the soiling and
the type of the flooring material.
 Bring the Eco mode switch into the de-
sired position.
Normal operation: The appliance works
at the maximum brush speed and the
highest suction performance.
Eco: The appliance works at reduced
brush speed and suction performance.
This also reduces the energy consump-
tion. The possible action time with one
charging cycle increases.
Cleaning
ATTENTION
Risk of damage to the floor covering. Do
not operate the appliance on the spot.
Risk of damage. Lift the vacuum bar before
pulling the appliance backwards over a
longer distance.
Detergent
RM 745
RM 746
RM 69 ES ASF
RM 69 ASF
RM 752
RM 754
RM 751
RM 732
EN
 Set the appliance switch to "I".
 Switch on "Detergent" button.
 Push the pedal of the suction bar lifting
device simultaneously down and to the
left and allow it to go up in order to lower
the suction bar.
 Pull the safety switch towards the push
handle, the brush drive and the applica-
tion of the cleaning solution are
switched on (if preset).
 Move the appliance over the surface to
be cleaned.
Shutting Down the Appliance
 Release the safety switch.
 Drive the appliance forward for another
1-2 m to draw off residual water.
 Push down the pedal of the vacuum bar
lifting device to raise the vacuum bar.
 Set the appliance switch to "0".

Emptying the waste Water tank

WARNING
Please observe the local provisions regard-
ing the wastewater treatment.
 Swivel the handle of the waste water
tank up and let it snap into place.
 Remove the waste water tank.
 Remove the cover of the waste water
tank.
 Empty the waste water tank.
Swivel the waste water tank sideways
during emptying so that the tank is com-
pletely drained.
 Rinse the waste water tank with clear
water.
 Reattach the waste water tank to the
appliance.
– 5
19

Quicklinks ausblenden:

Werbung

loading