Getting Started - XciteRC ALPHA-EGG Bedienungsanleitung

EN

Getting started

Before you begin please check:
• WARNING: Only start with a sufficiently full transmitter batteries (rechargeable batteries) and fully
charged drive battery – crash hazard!
• Check all parts for damage and dirt. Replace any damaged parts and clean the model, because dirt
increases the weight and therefore can degrade the flying qualities.
1. Press the ON/OFF switch
on the bottom.
• Switch on the transmitter. The red POWER LED of the transmitter flashes.
• Place the Quadrocopter on a leveled surface in the starting position (the charging socket shows the rear)
and move the left throttle lever all the way up and then back in the lowest position. The transmitter is no
connected to the ALPHA-EGG.
• Press the motor start / stop button on the transmitter. The motors start running at low speed.
NING: Do not touch the model anymore - risk of injury!
• Apply slowly throttle (left throttle lever up), motor speed increases and the ALPHA-EGG takes off.
• Once you have reached the desired altitude, release the throttle lever. The ALPHA-EGG now automatically
hoovers at this height.
• If the flight battery runs low, the motor speed is reduced and the Quadrocopter sinks automatically. Find
a suitable place to land safely. Charge the flight battery again.
24 24
2. The propeller arms will
open automatically.
Getting started
3. Press and hold the ON/OFF
switch approx. 1.5 s to
power on the egg.
XciteRC ALPHA-EGG
WAR-