Battery Charging; Getting Started - XciteRC 15008000 Bedienungsanleitung

Battery charging · Getting started

Battery charging

WARNING: Be sure to read all safety instructions regarding the use of rechargeable batteries. Charging
may take place only with the supplied charger on a fireproof surface and under constant adult supervision -
fire or explosion hazard!
• Connect the USB cable to a PC or appropriate power supply. The red LED lits.
• Connect the Quadrocopter battery with the charger.
• WARNING: The Quadrocopter battery is polarized. Check the side channels. Do not use force - fire
or explosion hazard!
• The red LED goes out to indicate charging. Charging time is about 40 minutes. If the battery is fully char-
ged, the red LED lights up again.
• Unplug the battery and the USB cable.
The flight time of the Quadrocopter is about 5-6 minutes.

Getting started

Before you begin please check:
• WARNING: Only start with a sufficiently full transmitter batteries (rechargeable batteries) and fully
charged drive battery – crash hazard!
• Check all parts for damage and dirt. Replace any damaged parts and clean the model, because dirt
increases the weight and therefore can degrade the flying qualities.
Insert battery
• Connect the battery to the Quadrocopter, the green LED's starts flashing.
• WARNING: The battery connector is polarized. Check the side channels. Do not use force - fire or
explosion hazard!
• Switch on the transmitter. The POWER LED flashes.
• Place the Quadrocopter on a leveled surface in the starting position and move the left throttle lever all the
way up and then back in the lowest position. This safety circuit prevents the rotor may start after turning
ON the Quadrocopter
XciteRC Rocket 65XS
PC
Insert the
battery in
the tray
Connect battery
EN
19