Headless Mode - Recalibration; Smartphone Operation (Wifi Version Only); Install The App; Connecting With Your Device - XciteRC ALPHA-EGG Bedienungsanleitung

Headless Mode · Recalibration · Smartphone operation

Headless mode - Recalibration

The Headless mode is ideal for beginners to fly the model safely. In headless mode, the
Quadrocopter always flys from the pilot's view. No matter how the model is in the air,
the front is always away from the pilot, left and right does not swap when the model is
flying towards the pilot.
The Headless mode is activated by pressing the headless mode button, the ALPHA-
EGGs LED's starts flashing to indicate the function. As long as the LED's flash, the
Headless mode is active. Press the control lever again to deactivate the headless mode.
cibrated if neccessary:
• Before you start place the model in front of you with a nose pointing away from you on a flat surface (fig.1)
• Now move both control levers into the lower left corner and hold them there for approx. 2 seconds (Fig.
2). The LEDs of the ALPHA-EGG start to flash, after approx. 2 seconds they light up again permanently
- the calibration was successful.
• You must also perform this calibration when the model is no longer stable after a hard crash or
immediately flips at the start.
Fig. 1

Smartphone Operation (WiFi version only)

Install the app

Scan the QR code on the box or to install the app on your Android ™ or iOS® Smartphone or Tablet.

Connecting with your device

1. Switch on ALPHA-EGG. The LEDs on the model are flashing slowly, it can now be connected with the
smartphone.
2. Open the WiFi settings on your smartphone and turn on WiFi. Now search in the WiFi list for KD **** „and
connect with it. Once the connection is successful, close the WiFi settings.
3. Now open the PANTONMA App and click on MY DRONE on the start page. The LEDs of the ALPHA-
EGG now light up permanently, it was successfully connected to the app. The live camera view is also
displayed on the screen.
XciteRC ALPHA-EGG
Note: to make sure that the headless mode works correctly, the model must rela-
Fig. 2
EN
27 27