Getting Started - XciteRC Rocket 55XXS 3D Bedienungsanleitung

Getting started

• Connect the USB cable to a PC or appropriate power supply. The red LED lits.
• Connect the Quadrocopter battery with the charger.
• WARNING: The Quadrocopter battery is polarized. Check the side channels. Do not use force - fire
or explosion hazard!
• The red LED goes out to indicate charging. Charging time is about 60-70 minutes. If the battery is fully
charged, the red LED lights up again.
• Unplug the battery and the USB cable.
The flight time of the Quadrocopter is about 6-8 minutes.
Getting started
Before you begin please check:
• WARNING: Only start with a sufficiently full transmitter batteries (rechargeable batteries) and fully
charged drive battery – crash hazard!
• Check all parts for damage and dirt. Replace any damaged parts and clean the model, because dirt
increases the weight and therefore can degrade the flying qualities.
• Move the throttle lever in the lowest position, then switch on the transmitter. The POWER LED flashes
(Fig. 1).
• Switch the Quadrocopter on, the LED's starts flashing.
• Place the Quadrocopter in the starting position and move the left throttle lever all the way up (Fig. 2) and
then back in the lowest position (Fig. 3). This safety circuit prevents the rotor may start after turning ON
the Quadrocopter.
• NOTE: Throughout the switching-on the Quadrocopter must be placed on a flat surface, because it
also initializes the gyro during this process. If this is ignored, the model will not fly properly and is hard to
control. In this case, turn everything off and start again from step 1.
• The model is ready to fly as soon as the „DI-DA-DO" melody is heard. The POWER LED of the transmitter
lights up solid red, also the LED's of the model stops flashing and lights up solid.
• Check the motor and servo functions.
• If the flight battery runs low, the motor speed is reduced and the Quadrocopter sinks automatically. Find
a suitable place to land safely. Charge the flight battery again.
XciteRC Rocket 55XXS
EN
19