Getting Started - XciteRC 15005000 Bedienungsanleitung

Getting started

• Connect the USB cable to a PC or appropriate power supply.
• Connect the helicopter battery with the charger.
• WARNING: The helicopter battery is polarized. Check the side channels. Do not use force - fire or
explosion hazard!
• The red LED lights to indicate charging. Charging time is about 60-70 minutes. If the battery is fully char-
ged, the red LED goes out.
• Unplug the battery and the USB cable.
The flight time of the helicopter is about 6-8 minutes.
Getting started
Before you begin please check:
• WARNING: Only start with a sufficiently full transmitter batteries (rechargeable batteries) and fully
charged drive battery – crash hazard!
• Check all parts for damage and dirt. Replace any damaged parts and clean the model, because dirt
increases the weight and therefore can degrade the flying qualities.
• Then switch on the transmitter. The POWER LED flashes.
• Connect the battery to the Quadrocopter (CHA).
• WARNING: The battery connector is polarized. Check the side channels. Do not use force - fire or
explosion hazard!
• Place the Quadrocopter in the starting position and move the left throttle lever all the way up and then
back in the lowest position. This safety circuit prevents the rotor may start after turning ON the helicopter
• The transmitter LED and the red helicopter LED will now light.
• Check the motor and servo functions.
• If the flight battery runs low, the motor speed is reduced and the helicopter sinks automatically. Find a
suitable place to land safely. Charge the flight battery again.
RC functions MODE 1
XciteRC Rocket 270M
EN
1
2
19