The Remote Control System; Transmitter; Battery Charging - XciteRC ALPHA-EGG Bedienungsanleitung

The remote control system

Here you get an overview of the remote control system of your XciteRC ALPHA-EGG and its various features
and settings. Before the first flight, you should absolutely have read and understood all these functions and
EN
settings.
• Do make sure that the transmitter is turned off - POWER-LED off.
• Now open the battery compartment cover on the backside of the transmitter. Remove the srew with the
screwdriver and open the cover (1).
• Insert 2 AAA-batteries into the battery compartment of the transmitter (2). Pay attention to the correct
polarity!
• Close the battery compartment cover.
• During flight the POWER LED must lit.
all, the model may not started – crash hazard! Change transmitter batteries immediately.
• WARNING: check the POWER LED also during operation. If the POWER LED starts to blink, stop
operation, switch the model off and replace the transmitter batteries – crash hazard!
ATTENTION: The maximum range of the remote control system is about 40 meters, do not fly
•
farther away under any circumstances!

Transmitter

Throttle lever
(press for
360° flips)
Headless-
Mode

Battery charging

WARNING: Be sure to read all safety instructions regarding the use of rechargeable batteries. Charging
may take place only with the supplied charger on a fireproof surface and under constant adult supervision -
fire or explosion hazard!
22 22
The remote control system · Battery charging
2x AAA batteries
ATTENTION: if the POWER LED flashes or does not light at
Trim
Status-LED
forward/reverse
ON/OFF-switch
[1]
[2]
Start/stop
motors
Control lever
(press to change
speed level)
Trim
left/right
Frequency: 2.4 GHz
Transmitting power: 10 mW
XciteRC ALPHA-EGG