Model Despriction; Propeller Replacement - XciteRC ALPHA-EGG Bedienungsanleitung

Model description · Propeller replacement
• Connect the USB cable to a PC or appropriate power supply. The red LED lits.
• WARNING: use USB adapters only with a max. output current of 1 A! A higher current can damage
the charging cable or the battery - fire or explosion hazard!
• Connect the Quadrocopter battery with the charger.
• WARNING: The Quadrocopter battery is polarized. Check the side channels. Do not use force - fire
or explosion hazard!
• The red LED goes out to indicate charging. Charging time is about 45 minutes. If the battery is fully char-
ged, the red LED lights up again.
• Unplug the battery and the USB cable.
The flight time of the Quadrocopter is about 6 minutes.

Model despriction

1. Propeller
2. Camera (WiFi version)
3. Motor
4. ON/OFF switch (press
to release the motor
arms, press and hold
1.5 s to power on the
egg)
5. Charging socket

Propeller replacement

Remove propeller
NOTE: To pull off the propeller, use a small screwdriver or pull it off with your fingers. Hold
the engine to not to pull it out of the arm with the propeller and damage the motor cable.
There are two different propellers, right and left (marked with A and B). Be sure to mount the
correct propeller after the change, otherwise the model will not fly.
XciteRC ALPHA-EGG
Install propeller
5
EN
23 23