Maintenance; Adjusting The Water Temperature - Geberit Know How Betriebsanleitung

EN

Maintenance

Adjusting the water temperature

The water temperature can only be
adjusted on Geberit washbasin taps with a
mixer.
1
Detach the cover plate. → see illustration
sequence
2
Adjust the water temperature on the mixer.
→ see illustration sequence
3
Test the water temperature.
4
Mount the cover plate. → see illustration
sequence
Activating cleaning mode
In cleaning mode, the flush actuation is suppressed
for 2 minutes. The washbasin tap and washbasin
can be cleaned during this time.
1
Cover approx. 1 cm of the IR window (at the
bottom on a deck-mounted tap, on the left
on a wall-mounted tap) for approx.
2 seconds until the green LED flashes (1x).
> 2 s
1
ü The washbasin tap is in the setting mode.
18
1 , page 268.
2 , page 269.
6 , page 273.
2
2
Cover approx. 1 cm of the IR window (at the
bottom on a deck-mounted tap, on the left
on a wall-mounted tap) for approx.
0.5 seconds (2x).
2x 0.5 s
1
ü The green LED flashes (1x).
ü The red LED flashes for 2 minutes. The
cleaning function is activated throughout
these 2 minutes.
Options:
• the function can be terminated
prematurely by covering the IR sensor for
approx. 2 seconds.
• you can also activate the function with
Geberit Clean Handy.
• the function can be blocked by a skilled
person.
Activating continuous flush
When the continuous flush is activated, the water
flows continuously for 2 minutes. The washbasin
can be cleaned with flowing water, for example,
during this time.
1
Cover approx. 1 cm of the IR window (at the
bottom on a deck-mounted tap, on the left
on a wall-mounted tap) for approx.
2 seconds until the green LED flashes (1x).
> 2 s
1
ü The washbasin tap is in the setting mode.
2
2
2011761803 © 09-2016
967.455.00 0 (00)