Use Only As Authorized - Scheppach Basa 3.0v Originalbetriebsanleitung

before starting up.
tered form.
does not turn.
use the appropriate
(Special accessory roller stands).
to the work piece.
the lower table plate half.
switching off.
the motor switched off and with the saw band at a stand-
still.
if only minor changes of place are envisaged. Properly
reconnect the machine to the supply mains before re-
commissioning.
the power supply plug.
m Use only as authorized
m CE tested machines meet all valid EC machine guidelines
as well as all relevant guidelines for each machine.
machine before beginning work.
The operator is responsible for all other persons in the
working area.
the machine.
to the machine are always complete and perfectly leg-
ible.
designed exclusively for sawing wood, material similar to
wood, and non- ferrous metals and steel.
essed is may not exceed the bench size in the standard
version. Clearance width: 306 mm, Clearance height:
205 mm
of the table top, the table extension or the dolly (special
accessories) must be used.
it is equipped with a special saw band dolly (special
accessory) and a operated at an adapted cutting speed.
connected to a vacuum exhaust unit. Use the dust ex-
tractor to remove matchwood or saw dust. The vacuum
support flow rate must be 20 m/s. Subatmospheric pres-
accessory.
working aids for bracing.
Type ALV 2 Art. No. 7910 4010 230 V/50 Hz
Type ALV 10 Art. No. 7910 4020 400 V/230 V/50 Hz
-
ter a 2-3 second delay after the machine tool is turned
on. This avoids overloading the circuit fuse.
unit remains on for an additional 2-3 seconds and is
then automatically switched off. Remaining dust is
thereby removed by vacuum exhaust, as required by
German regulations governing hazardous materials. This
results in savings in electricity consumption and reduces
noise levels, as the vacuum exhaust unit is on only dur-
ing machine tool operation.
lations must be used for suction in commercial areas.
tors while the work machine is in operation.
condition in accordance with its designated use and the
instructions set out in the operating manual, and only
by safety-conscious persons who are fully aware of the
risks involved in operating the machine. Any functional
disorders, especially those affecting the safety of the
manufacturer as well as the technical data given in the
calibrations and dimensions must be adhered to.
generally recognized safety-technical rules must also be
adhered to.
ed by persons familiar with it and instructed in its opera-
tion and procedures. Arbitrary alterations to the machine
release the manufacturer from all responsibility for any
resulting damages.
and original tools made by the manufacturer.
is not responsible for any damages resulting from unau-
thorized use; risk is the sole responsibility of the opera-
tor.
-
Prepare the workplace where the machine is to be placed.
tions. The machine is designed to operate in closed rooms
is insured by attachment to the ground with 4 screws (Fig.
14).
The machine may only be transported with suitable lifting
devices (crane or fork lift). The connection point for the
rope (crane) is on the upper band wheel cabinet.
Set-up
Transport
-
-
-
-
-
11