Machine Description - Scheppach Basa 3.0v Originalbetriebsanleitung

Scope of delivery
Passage width
Passage height
Table size
Cutting speed
Saw band length
Height up to tabletop
Height up to tabletop with
underframe
Overall height without
underframe
Overall height with un-
derframe
Overall width
Overall depth
Slewing range of the table
Overall weight without
underframe
Overall weight with un-
derframe
Suction connector
Volumenstrom
stat. under pressure (20
m/sec)
Drive
Motor
Nominal consumption
P1 (kW)
Delivery of power P2 (kW)
Noise parameters
The noise emission values determined according to EN
23746 for the sound level and according to EN 31202
pendix A.2 of EN 31204) for the sound level at the work-
place are as follows, based on the working conditions listed
in ISO 7904 Appendix A:
Sound level in dB
Operation LWA = 100.2 dB(A)
Sound level at the workplace in dB
Idle running LpAeq = 64.1 dB(A)
A measurement uncertainty allowance K = 4 dB applies to
the mentioned emission values.
12
Basa 3.0v
Band saw
Sawing table
Longitudinal stop
Dust bag connector
Push stick
Accesory Bag
Hexagonal spanner SW 10/13
Hexagonal socket head wrench
SW 4/SW 5
Operating instructions
306 mm
205 mm
400 x 548 mm
370 – 750 m/min
2360 mm
515 mm
1050 mm
1150 mm
1680 mm
825 mm
540 mm
-8° – +45°
69 kg
77 kg
Ø 100 mm
3
565 m /h
900 Pa
Alternating Rotary current
current
0,80 0,70
0,55 0,55

Machine description

Due to its perfected design, the machine offers a versatile
application for processing wood and plastics in the work-
shop.
guard and an articulated cover. Upon opening the cover,
the machine is switched off. Switching on again is only
possible with the cover closed. The non-cutting part of the
to the sawbelt guide, the latter being protected against
wheel. The non-cutting part of the sawbelt under the table
The swivelling range of the table from -20° to +47° allows
versatile cutting possibilities (e.g.)
Please consult also the working hints in the operating in-
structions.
Assembly tools
1 engineer's wrench SW 10/13
For reasons of packaging technology, the tabletop, the han-
dle, and the handwheel are not mounted.
Installation of the tabletop, Fig. 1
1. Open the case cover, and set the slewing segments to
30°.
2. Loosely screw the tabletop.
Fig. 2
Turn the tabletop into the 0° position, and tighten the
clamping lever.
-
Fig. 3
Align the tabletop as follows:
1. Put a straight wood border with a length of approximate-
ly 50 cm on the table and put it against the upward and
downward parts of the saw band.
2. Put a shifting square against the wood border and the
groove edge of the table. Align the table, and fasten the
two front hexagon head cap screws on the table.
3. Release the clamping lever of the slewing segments by
means of a quarter turn, and pull the back segment out-
wards. Fasten the two back hexagon head cap screws on
the table. Thus, you achieve a smooth slewability.
Fig. 4
1. Use the adjusting screw on the rear of the machine to
Completion