Main Clutch Adjustment; Parking Brake Adjustment - Ransomes Super Certes 51 Sicherheits-, Bedienungs- Und Wartungshandbuch

8.14

MAIN CLUTCH ADJUSTMENT _____________________________________

1. Undo clutch cover fixing bolts. The cover can then
hinge outwards leaving the clutch uncovered.
2. Using a feeler gauge [B] adjust [A] until the gap
is between 0.38mm (0.0014in) and 0.50mm
(0.0020in).
3. Replace the cover and tighten screws.
Important:
After any adjustment of the main drive clutch the
system check outlined in section 7.2 should be
carried out to ensure the correct operation of the
Operator Presence System.
8.15

PARKING BRAKE ADJUSTMENT __________________________________

Refer to Fig 8.15a for Marquis & Super Bowl parking
brake.
Refer to Fig 8.15b for Super Certes parking brake.
1. Secure brake cable to abutment on the
handlebar.
2. Route brake cable through brake bracket
abutment, pull inner cable tight through pivot pin,
and secure with screw [B] (Fig 8.15a).
3. With Parking brake lever activated adjust locking
nuts [A] in (Fig 8.15a & 8.15b) to ensure the brake
band is exerting enough force on the drum to
prevent the machine from moving on a 15° slope
and is clear of the drum in the off position.
8 ADJUSTMENTS
Fig 8.14
A
B
Fig 8.15a
A
Fig 8.15b
en-45