Trailing Seat; Verti-Groom Attachment - Ransomes Super Certes 51 Sicherheits-, Bedienungs- Und Wartungshandbuch

9.3

TRAILING SEAT _________________________________________________

If required a trailing seat may be attached to the machine by means of a single pin coupling. Only a Ran-
somes trailing seat (LMAA747) should be used with these machines.
FITTING THE TRAILING SEAT TO THE MACHINE
1. Position trailing seat behind the machine.
2. Rotate locking pin forward.
3. Position ball cup over ball on brake bracket.
4. Ensure ball is fully located in cup.
5. Rotate locking pin rearwards.
9.4

VERTI-GROOM ATTACHMENT _____________________________________

SPECIFICATION
Number of blades
Diameter
Blade spacing
Depth adjustment
Speed of rotation
CAUTION
DO NOT Make Sharp Turns When The
Trailing Seat Is Tted As This May Cause
The Mower And Trailing Seat To Jack-Knife
Causing Loss Of Control.
CAUTION
When Mowing Over Uneven Ground Care
Should Be Taken When The Trailing Seat
Is Fitted As An Upward Force On The Hitch
May Cause Disconnection.
51 661
31 35
53
72mm (2 / in)
64
19
15mm ( / in)
32
5
8mm ( / in) above front
16
roll to level with front roll
2500 rpm max.
9 ACCESSORIES
Fig 9.4
en-47