Accessories; Brush And Comb Set; Transport Wheels (Super Certes Only) - Ransomes Super Certes 51 Sicherheits-, Bedienungs- Und Wartungshandbuch

9

ACCESSORIES

9.1

BRUSH AND COMB SET _________________________________________

According to conditions a brush or comb can be fitted.
It is not advisable to use the brush in wet conditions.
To fit either of these units:
1. Remove bolt [A] on both sides of the front roll.
2. Replace the bolt together with the bracket [B]
in between it and the side plate, replace the
outside locknut and tighten securely.
3. Slacken the nuts [C] at each end of the brush
or comb.
4. Slide the screwed studs into the brackets.
5. Tighten the nuts firmly.
NOTE: The washer should be placed immediately behind the nuts.
The brush or comb can be moved up or down to suit varying conditions but always ensure that the unit is
level before re-tightening the nuts.
If the bristles of the brush, through continuous use, wear at an angle, reverse the brush unit in its frame.
NOTE: It is not necessary to remove the brackets to remove the brush or comb
9.2

TRANSPORT WHEELS (SUPER CERTES ONLY) _____________________

These wheels are driven off the extension of the rear roll
spindle.
To fit or remove wheels:
1. Raise the rear roll clear of the ground by means of
the kickstand.
2. Hold the quick release clip down [A].
3. Fit or remove the wheels as required.
en-46
B
A
Fig 9.1
A
Fig 9.2
C