Control Cabinet Installation; Ambient Conditions; Installation Instructions - KEB COMBIVERT S4 Betriebsanleitung

Control Cabinet Installation

3. Control Cabinet
Installation
GB

3.1 Ambient Conditions

3.2 Installation
Instructions
GB 8
Altitude of site max. 2000 m –– A power reduction of 1 % per
100 m must be taken into account for site altitudes of 1000
m and more above sea level, i.e. 1500mNN = 95% P
Max. permissible limit values: Servo controller KEB COMBIVERT S4
Coolant inlet temper.- /
Ambient temperature
during operation
Storage temperature
Transport temperature
Relative humidity max.
– Stationary installation and earthing of the servo controller KEB
COMBIVERT S4.
– At the installation of the servo controller observe minimum distance to
adjacing elements (see Installation Instructions).
– No moisture or water shall penetrate into the servo controller.
– Avoid penetration of dust into the servo controller. For installation in a
dust-proof housing sufficient heat dissipation must be provided.
– Do not operate the servo system KEB COMBIVERT S4 in explosion-
protected rooms.
– Ensure sufficient heat emmission of the servo motor.
– Protect servo controller and servo motor against aggressive gases and
liquids.
– Avoid any impacts or shocks on the servo motor.
– Use suitable devices for fitting or taking off drive elements on the motor
shaft (toothed wheels, belt-pulleys, clutches etc.)
If other consumers which produce electric or magnetic fields or which
effect the power supply are located in the vicinity of the servo controller,
they must be positioned as far away as possible from the servo controller
and steps must be taken to suppress interferences.
-10 °C...+45 °C
-25 °C...+70°C
-25 °C...+70°C
max. 95 %, no condensationg
(identification "F" DIN 40040)
Climatic category 3K3
Nominal