Accessories; Ec Declaration Of Conformity - Scheppach cs 55 Originalbetriebsanleitung

Accessories

RAIL
m Maintenance
If specialist personnel must be brought in for extraordinary
ser vice or repairs during the warranty period and thereaf-
ter, please contact a service provider recommended by us or
con tact the manufacturer directly.
• Overhauls, maintenance work, cleaning, as well as the
eli mi nation of any malfunctions must only be under-
taken af ter turning off the motor.
• All protective and safety equipment must be rein-
stalled immediately upon completion of any repair or
maintenance work.
ReguLAR MAInTenAnCe
The regular maintenance decribed above and in the para-
graph below can be carried out by unskilled personnel.
• Do not oil the plunge cut saw, cause cutting must be
carried out in dry conditions; all rotating parts are
self-lubricating.
• During maintenance, wear protective gear if possible
(accident-prevention goggles and gloves).
• Remove cuttings when necessary both from the cutting
area, work surfaces and support bases.
Use of an aspirator or brush is recommended.
ATTenTIon: Do not use compressed air jets!
• Regularly check blade conditions: if difficulties should
arise during cutting, have it sharpened by skilled per-
sonnel or replace it if necessary.
ASSISTenCe
When in need of skilled personnel for special main-
tenance, or for repairs, both during and following the
guarantee pe riod, always apply to authorized centres for
assistance or directly to the manufacturer if there is no
authorized centre in your area.
DISPoSAL oF THe MACHIne.
Once its operating activity is finished, the disposal of the
machine must take place through a normal collection and
disposal Center for industrial waste.
18
We herewith
1400 MM
Holzbearbeitungsmaschinen GmbH, Günzburger Str. 69, D-89335
Ichenhausen
that the machine described below due to its con struc tion and design
and in the version delivered by us complies with the relevant provisions
of the following EC Directives.
In case of a modification of the machine this declara tion ceases to
be valid.
Benificary: Werner Hartmann
Machine description:
Plunge cut saw
Circular saw, hand held
to saw wood with an appropriate saw blade
Machine type:
cs 55, Art.-nr.
490 1802 918
Applicable EC Directives:
eC machine directive 2006/42/eC,
eC Low voltage directive 2006/95/eC,
eC-eMv directive 2004/108/eC.
Applied harmonized European standards, especially
en 60745-1, en 60745-2-5, en 55014-1, en 55014-2, en 61000-3-
2, en 61000-3-3, en 55014-1/A2:2002, en 61000-3-3/A2:2005, en
610003-3/A2:2005, en 61000-3-11:2000, en 55014-2/A1:2001, en
61029-2-9:2002
Place, date:
Ichenhausen, 02.05.2011
Handtekening:
Werner Hartmann (Head of Technical Innovation)

eC Declaration of Conformity

declare, scheppach
490 1802 000, 490 1802 901,
Fabrikation von
490 1802 902,