Technical Specifications; Troubleshooting - STEINEL IS 2160 ECO Bedienungsanleitung

Technical specifications

Dimensions: (H x W x D) 113 x 78 x 73 mm
Output:
Incandescent lamps, 600 W max. at 230 V AC
Fluorescent tube, 500 W max.
at cos ϕ = 0.5, inductive load at 230 V AC
4 x 58 W max., C ≤ 88 µF
at 230 V AC
Connection: 230 – 240 V, 50 Hz
terminal block suitable for following supply leads:
3-core Ø 1.5 or 2.5 mm
Angle of coverage: 160° with sneak-by guard
Pivoting range: 40° horizontal, 70° vertical
Reach: 12 m max.
Light threshold: 2 – 2000 lux
Time setting: 8 sec. – 35 min. (factory setting: 10 sec.)
Light threshold: 2 – 2000 lux (factory setting: 2000 lux)
Enclosure: IP 54
Temperature range: -20 °C to +50 °C
*1)
Fluorescent lamps, low-energy lamps, LED lights with electronic ballast
(total capacity of all ballasts connected below the level stated).

Troubleshooting

Malfunction Cause
Without power Fuse blown, not switched

'ON'
Short circuit

Does not switch 'ON' Twilight setting in

nighttime mode during
daytime operation
Bulb blown

Mains switch 'OFF'

Fuse blown

Detection zone not

properly targeted
16
*1)
or 5-core Ø 1.5 mm
2 2
Remedy
Renew fuse, switch 'ON'

mains power switch,
check wiring with voltage
tester
Check connections

Readjust

Replace bulb

Switch 'ON'

Renew fuse, check

connection if necessary
Re-adjust

Malfunction Cause
Does not switch 'OFF' Continued movement in

detection zone
Light is in detection zone

and keeps switching on
as a result of temperature
change
Set to continuous

operation by indoor
series switch
Keeps switching 'ON'/'OFF' Light is in detection zone

Animals moving in

detection zone
Switches 'ON' when it
Wind is moving trees and

should not
bushes in the detection
zone
Cars in the street are

being detected
Sudden temperature

changes due to weather
(wind, rain, snow) or air
expelled from fans or
open windows
Reach modification
Change in ambient

temperatures
Remedy
Check detection

zone and re-adjust if
necessary or fit shrouds
Readjust zone

Set series switch to auto-

matic mode
Change zone, increase

distance, reduce output
Tilt sensor higher or

apply specific shrouds,
adjust detection zone or
fit shrouds
Adjust detection zone or

fit shrouds
Change detection zone,

tilt sensor down
Adjust detection zone or

change site of installation
When it is cold, shorten

reach by tilting sensor
down
When it is hot, tilt sensor

up
17