Preparations For Commissioning; Charging The Drive Battery - Reely Wavebreaker RtR Bedienungsanleitung



8. Preparations for Commissioning

The model ship "Wavebreaker" is delivered ready for operation. Only a few steps are required for commissioning.
Before taking the model into operation, read each section carefully. The stages are illustrated for better
understanding.
Please note that the numbers in the text always refer to the components in the illustration to the right.
Only carry out the steps described in the different sections if you have completely understood the procedure
and know exactly what to observe.
a) Charging the Drive Battery
Important!
The drive battery is charged with the charger from the scope of delivery. Since this charger does not have
any switch-off automatic, you need to supervise the charging process and disconnect the battery from the
charger in time.
• Connect the charger (figure 2, item 1) to a pro-
per mains socket.
• Connect the drive battery (figure 2, item 2) to
the charger cable. Observe the polarity. The
battery (figure 2, item 3) and charger (figure 2,
item 4) plug connection is protected against
polarity reversal. The charging cable retention
bracket (figure 2, item 5) must latch in the
battery plug's latch (figure 2, item 6).
• Once the battery has been connected to the
charger, charging commences. Write down or
remember the starting time of charging.
• Charging is not completed automatically by the
charger.
When the battery is fully charged, it must be
disconnected from the charger. You can
recognise a fully charged battery because it has
heated to hand-warmth.
For a flat rechargeable battery. this is the case after approx. 4 hours. After this period at the latest, you need to
disconnect the battery from the charger. If a battery that is not fully discharged is charged, the maximum permissible
charging time reduces accordingly.
Figure 2
27