Conrad MT-7005 Bedienungsanleitung Seite 14

• Before changing the effective range, the test prods
must be removed from the measuring object.
• Always check your measuring device and the mea-
suring leads for damage before taking measure-
ments.
• Use the enlosed measuring leads for taking measu-
rements. They are the only types of measuring leads
authorized for this measuring device..
• To avoid electric shock, pay attention to not contac-
ting – directly or indirectly -the test prods and the
measuring inputs (measuring points) during the
measuring procedure.
• The voltage to earth applied to the measuring inputs
of the measuring device must not exceed 300 VDC/
VACrms (CAT II).
• Do not use the measuring device in rooms or under
contrary environmental conditions, where inflamma-
ble gases, fumes or dusts exist or are likely to exist.
For your own safety, absolutely avoid dampening or
34
Meßtoleranzen
Angabe der Genauigkeit in ±(%, bezogen auf den Ska-
lenendwert)
Genauigkeit 1 Jahr lang bei einer Temperatur von
+23°C ±5K, bei einer rel. Luftfeuchtigkeit von kleiner
als 75 %.
Betriebsart Meßbereich
Gleichspannung alle Bereiche
2,5/10/50/250/500 V
Eingangsimpedanz: 2 kOhm pro V
Wechselspannung alle Bereiche
10/50/500 V
gültig für den Frequenzbereich von 45 Hz bis 100 Hz
Eingangsimpedanz: 2 kOhm pro V
Gleichstrom alle Bereiche
0,5/10/250 mA
Widerstand Rx10, Rx1k
Batterietest 1,5-V-Bereich
125 mA Laststrom
9-V-Bereich:
10 mA Laststrom
Genauigkeit
±5%
±5%
±5%
±5%
±10%
±5%
27