D Resistance Measurement - Conrad MT-7005 Bedienungsanleitung

Im Vollkreis angeordnet, sind hier die verschiedenen
Meßbereiche (im Uhrzeigersinn, ab "OFF"), durch Dre-
hung des Schalters, auswählbar:
V ... – = Gleichspannungsmessung (5 Bereiche)
mA ... – = Gleichstrommessung bis max. 250 mA
(3 Bereiche)
BAT = Batterietest (1,5V-Rundzellen, 9-V-Block-
batterie)
V ~ = Wechselspannungsmessung (3 Bereiche)
Ω
= Widerstandsmessung (2 Bereiche)
D Gebrauchslage
Betreiben Sie das Multimeter stets waagerecht so, daß
Sie die Anzeige lesen können bzw. die Analoganzeige
nach oben zeigt.
16

D Resistance measurement

Make absolutely sure that all circuitry,
circuits and components to be measu-
red as well as other measuring objects
are voltageless.
Please adhere to the following instructions for resi-
stance measurement:
1. Set the turn switch to "Ω" (2 effective ranges: Rx1k
up to 1 MOhm and Rx10 up to 10 kOhm).
2. Check the measuring leads for continuity by joining
the test prods. By this, the resistance value will be
set to approx. 0.1 to 0.2 Ohm (= resistance of the
measuring leads). At the left side of the multimeter
you will find a controller designated with "0 Ohm
ADJ" which stands for balance. Adjust the pointer to
"0 Ohm" using the controller while having the test
prods short-circuited („joined"). Then separate the
test prods.
3. Now, connect the test prods to the measuring object.
45